Print

[bighed]

Im into slapping lol..............

Anyway, as yet my next day off from work is monday (could soon change) so will have a go at making the false floor etc for the box and amps to sit on.....

[bighed]

Have managed to squeeze in an hour on the Senator today. Have cut out the false floor for in the boot and positioned where I would like the amps to go (subject to change obviously) I still need to do the framework for underneath which will give me the clearance needed for all the cables and distribution blocks etc. The four 8" woofers I will be running will be in 2 seperate boxes approx 0.5 cuft each, in an iso config, tuned to around 35hz. The boxes will be in the spaces left and right either side of the Titan amp. All will be trimmed in grey carpet. I have also deadened one of the doors. I wasnt going to go this far as was only going to do round the front speakers but thought what the hell....

[Netwalker]

I like them. Are there going to be some lights in there to give a little more bling?

[vinny_69]

you could always get Damo to help   

[bighed]

Only the original boot light.

[The Boss]

looking good there buddy. A couple of small lights would look good in there, although using the same amount of lighting as what I supplied to Chelsea would be over kill. 

[bighed]

Have finally managed to get the old exhaust off today after much delaying. The problem I had was that the bolts had been rounded off on the joints on the cats so had to drop it all down as one piece. need to get the angle grinder out tomorrow and cut the bolts off from the rear side of the cats as have got new centre sections and backbox to fit

[vinny_69]

that's one hell of an exhaust dont for get your eye protection when using angle grinders im still suffering 

[bighed]

i wouldnt dream of not wearing goggles vinny. Safety 1st!

[vinny_69]

i wouldnt dream of not wearing goggles vinny. Safety 1st!

  i think i have learn me lesson 2 

[Netwalker]

that's one hell of an exhaust dont for get your eye protection when using angle grinders im still suffering 

Should have consulted our resident Health and Safety expert first. Chaz would have told you what precautions to take

[bighed]

Just a close up of the monstrosity of an exhaust a previous owner butchered onto my senator.

[vinny_69]

What a cool bodge i bet it sounded like a monster

[bighed]

Sounded crap tbh.  Well again slow progress. Only managed an hour yesterday to trim false floor. Amps will be screwed down on top and all the cables will be hidden underneath.

[Netwalker]

Looking good so far.

Any progress is better than none.